Nikon SB-800 CLS Remote Flash Settings

Here is a quick video to demonstrate how to setup the SB-800 to be a slave flash to the camera’s pop-up flash.

12 Comments

  1. Habib Emailing
    April 27, 2015 at 9:27 pm #

    How do i get the 800 out of remote 

  2. Paul Shoffner
    April 27, 2015 at 9:57 pm #

    Now…How do you get OUT of this mode?

  3. Darla Hueske
    April 27, 2015 at 10:54 pm #

    Thank you. Very clear and helpful.

  4. dax Green
    April 27, 2015 at 11:31 pm #

    I did the whole set up like you demonstrated and it still didnt flash?

  5. Ivan Beoulve
    April 27, 2015 at 11:37 pm #

    wait when you fired that sample shot, did the built in camera flashed too?
    isn’t that just slaving the flashgun?

  6. cuisineisabelle
    April 28, 2015 at 12:20 am #

    Many thanks. Very helpfull

  7. gonzalo san cristobal
    April 28, 2015 at 12:59 am #

    I can only say the same as Edgar ´t… very helpfull video

  8. Ellen Rogers
    April 28, 2015 at 1:57 am #

    Thank you!!! Very helpful. :)

  9. Alexander Heckel
    April 28, 2015 at 2:05 am #

    thanks a lot. Very helpfull

  10. Edgar 't Hart
    April 28, 2015 at 2:50 am #

    Thanks. Had the SB-800 for 5 years, never knew how to do that.

  11. Anas Mahdi
    April 28, 2015 at 3:49 am #

    i do all the steps but still can’t do it

  12. Amos Mmopi
    April 28, 2015 at 4:27 am #

    HOW DO i set a remote flash using Nikon D2X